Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2511 reverse telnet

Hi again . now I was able to get from comm-server 2511 to 2610 when I canfigured the loopback0.. now I wan to getback to 2511 com-serv its says on the doc that I need to do Ctrl+shift 6, twice// I did but I am still on the R1 PROMT

do I need to config a loopback0 on 2610 so it will go back to 2511.. ?

Thanks

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: 2511 reverse telnet

Type "Ctrl+shif-6" then "X"

HTH

SSLIN

Re: 2511 reverse telnet

Please follow these steps

1. Press the keys "Ctrl","shift","6" at the same time.

2. Release the above keys.

3. Hit the key "x"

Hope this works. If not, let me know.

SSLIN

8 REPLIES

Re: 2511 reverse telnet

Type "Ctrl+shif-6" then "X"

HTH

SSLIN

New Member

Re: 2511 reverse telnet

you mean hit the key Ctrl+shif-6 the letter X or type it ..

Re: 2511 reverse telnet

Please follow these steps

1. Press the keys "Ctrl","shift","6" at the same time.

2. Release the above keys.

3. Hit the key "x"

Hope this works. If not, let me know.

SSLIN

New Member

Re: 2511 reverse telnet

thanks will try and let you know, not near the lab today/

New Member

Re: 2511 reverse telnet

I was able to got from 2511 to R1.. I did what its says .. but i does not work.

R1#x

% Ambiguous command: "x"

R1#xR1#x

R1#show session

% No connections open

R1#show sessions

% No connections open

New Member

Re: 2511 reverse telnet

I was able to firuge it out.. I guess I ahve to be on enable user mode.. then apply the command ..

Thanks for the help

R1#disable

R1>

2511sw#

Re: 2511 reverse telnet

Hi, ocporbust

That sounds strange. I had used this command for thousands times. It worked no matter the router was on user mode or exec mode.

Would you please try it again?

Regards

SSLIN

New Member

Re: 2511 reverse telnet

sorry for the delay of my response, I did it this time and it did work from the ex mode.. Thanks

128
Views
4
Helpful
8
Replies