Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

2900XL Reboots while configuring

Been trying to config a 2924XL switch via telnet. Always within Two(2) minutes. the switch reboots and knocks the telnet session down.When I unplug the switch it will once again hookup but only for a couple of minutes.

Any suggestions ?

Thanks;

2 REPLIES
Community Member

2900XL Reboots while configuring

Do you recieve any error messages, either before the reboot, or durring startup? What software version are you running? Does this only happen while using Telnet? Can you copy/paste what you are doing on the swtich from before the crash until after the reboot (remove personal details as necessary)?

Cisco Employee

2900XL Reboots while configuring

There is not enough information to determine the cause of the problem. Hook up a device to the console and copy all of the output produced. With that we should be able to tell more. 

470
Views
0
Helpful
2
Replies
CreatePlease to create content