Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2960G uplink

hi guys,

i've got four 2960G-48TC-L switches. i have to uplink all four to a catalyst 4500 with a single GLC-SX-MM, and i figured i would connect the switches to each other with GLC-T modules, and uplink the one that is on top of the stack. so the question is: is it lame to connect three of the switches to only one, or should they be connected to each other as well?

2 REPLIES
New Member

Re: 2960G uplink

well i just realized, that the four uplink port on the 2960G-48TC-L are dual purpose ports, so i'll just use rj45, i don't need the GLC-T at all (but correct me if i'm wrong)

New Member

Re: 2960G uplink

yes, you can just use the copper ports rather than the fiber ports if distance between the 2960 and the 4500 is not a problem

138
Views
0
Helpful
2
Replies
CreatePlease to create content