I have 5 WS-C3550-48-SMI switches on 2 different floors in a single building. There are 3 on one floor and 2 on another. There are 2 RPS 300 units (one for each floor). All 5 3550s are showing RPS is FAULTED with the show env all command.
A visual check of the RPS units shows all green LEDs. I had the onsite tech take both RPS to standby and back to active and still no change in status.
There are zero logging events (logging level is debugging). It is possible that the site lost power due to weather, but the fault is still there.
Is there a reset command on the 3550 to initialize the fault? Do I need to reset all 5 switches?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.