Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

4402 WLC, Netgear Switch, 802.1q

Hi,

I'm trying to get a link up between port 1 on my WLC and a GIG-E port on a netgear FS526T switch. I currently have it configured like this:

- 4402: management interface with a VID of 2 on distribution port 1 (copper glc).

- FS526T: VLAN ID's 1, 2 configured. Port PVID is 2 for every port. Ports are set to untag exiting frames, except for frames exiting port25 (which connects to the WLC).

Link status stays down on the distribution port; any idea what I have configured wrong?

On the WLC, >show port 1 reports the link status as down.

I had the link up on another switch but need to get it working on this one.

3 REPLIES
Silver

Re: 4402 WLC, Netgear Switch, 802.1q

It may be misconfiguration is one of the reason. Colud you paste show run output.

Community Member

Re: 4402 WLC, Netgear Switch, 802.1q

I later tried a couple other switches with no luck (and many different switch vlan config's). I've got a new 1000BASE-T SFP and another switch (HP) coming in today.

Thanks for the help!

Community Member

Re: 4402 WLC, Netgear Switch, 802.1q

It was the SFP! Got link now.

284
Views
0
Helpful
3
Replies
CreatePlease to create content