adding 3750 to stack

[dimaggra015]

Hello,

I just moved a 3750 switch from a stack where it was #4. I wiped out the config by holding in the mode button, then checked it through the console port.

Then I installed it in another stack as the #3 switch, removing the stack cables while the other 2 switches were powered up and connecting them to the unpowered switch #3.

I then powered up the #3 switch. Everthing seemed to work fine except that the switch shows up as #4 instead of three. Did I miss something here?

[Collin Clark · Accepted solution]

You can renumber the switch. See the Add a Provisioned Switch to a Switch Stack paragraph. The link should answer your other questions as well. For even more detailed info, check the configuration guide for the 3750s.

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#Add

[vvasisth · Accepted solution]

If you manually change the stack member number by using the switch current-stack-member-number renumber new-stack-member-number global configuration command, the new number goes into effect after that stack member resets (or after you use the reload slot stack-member-numberprivileged EXEC command) and only if that number is not already assigned to any other members in the stack.

Here is the link for the bible of 3750 STACk :-

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_20_se/configuration/guide/swstack.html

Regards,

Varun

[dimaggra015]

Should have posted back before. Thanks for the input.