is there a step by step guide on how to manage AP541n with a 2504 controller?
I have done the initial config on the 2504 but somehow the AP does not join and i can not find what would be a correct setting for the AP. How does that work anyway. In all documentation i found the AP somehow finds the controller, but in my case it does not.
I recently retired a number of 541's because they do not support an enterprise wireless configuration like you are attempting. Between themselves they can form a cluster but they are not able to join a with a controller.
You will need new access points to use with your WLC.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...