Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

back to the lab again

2 router 2610 and 2501 .. connected by dte/dce .. clock rate is set on the dce.

labr1= s0 192.168.1.2

labr2= s 0/0 192.168.1.3

no shut on both. I am trying to have this interfaces talk to each other

no luck so far

Thanks again

2 REPLIES
Community Member

Re: back to the lab again

Are the interfaces up/up? If not, what does "show controller serialxy" show?

- thomas

Community Member

Re: back to the lab again

Thomas with little clear mind I was able to figure it out.. love troubleshooting ...

Thanks

146
Views
3
Helpful
2
Replies
CreatePlease to create content