Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Balancing load over DSL cards

I need help.I'm trying to configure one FastEthernet with 5 Vlans,and need to do traffic balancing over two Dsl cards.How can I do it?

I have attached the config of my router.

Thanks in advance.

1 REPLY
Cisco Employee

Re: Balancing load over DSL cards

Cant see the config .. but at a very high level. Two default static routes pointing out to each of the remote DSL gateway IP addresses should do the trick.

CEF will take care of the per destination load balancing once the routing is configured correctly.

ip route 0.0.0.0 0.0.0.0

ip route 0.0.0.0 0.0.0.0

I assume here that your destination is the internet hence the default route. If not replace 0.0.0.0 by whatever destination you want to balance out to.

113
Views
0
Helpful
1
Replies