what would be a basic internet config on a t1 wic w/ a public ip and two fast ethernet ports? 1841 router. i'm trying to write up a checklist of everthing the config should accommodate so i don't leave anything out.
make sure the framing and linecode are configured right. check this with the ISP... if your LAN is on a private range, you also might need to do a NAT/PAT over the T1 interface.. for NAT examples refer to the CCO. you also need a default route to the outside towards the t1 interface...
Hope this helps.. all the best. rate replies if found useful..
thatnk you Raj, yes, the config you shared is familiar to me from a poit-to-point i worked on. i am concerned with the intra net behind the t1 which is a static ip network but private nonetheless. thank you again.
cool. if u gotta private network, obviously you will do a nat/pat out the T1 connectivity.. thanks for your response.. mark the case as solved (if it solves ur query), which can be useful for others when searching.. rate replies if found useful..
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...