I have 4 CE500 and 1 2960G. I would like to know an example of a good connction configuration.
Right now my setup is far from optimal because I had some problems. For some reasons I could not have my IP phones to register with the Call Manager if all 4 CE 500s were connected in the 2960G. I needed to connect all my CE500 switches together using a random port (not the 1GB port) in order for them to register with the Call Manager.
This setup wont work with my ip phone if I dont link the CE500s together using a random port :( I dont know why.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...