Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

changing the subnet mask

we're connecting 2 offices via the ethernet port on a 1710 router on the far end and the fastethernet port on our end.

in the original config we planned on using a .248 mask and life is good...the circuit is up and running.

now we have been told that we need to change the mask to .240 to acommidate a few more IPs.

it should be fairly easy/painless to change the mask? right?

Am I missing something?

Any thoughts?

thanks, gary

3 REPLIES
Hall of Fame Super Blue

Re: changing the subnet mask

Hi Gary

Provided the .240 covers the addressing used in the .248, these addresses haven't been used anywhere else and the .240 falls on a natural subnet range you should be absolutely fine to do this.

HTH

Jon

Re: changing the subnet mask

yes as long as you are not having overlapping address, it should be fine.

Remember you might need to update your routing protocol if any with this new information to properly forward packets

Narayan

New Member

Re: changing the subnet mask

Great, thanks.

I don't think the new IPs will overlap. But that is something I will keep in mind.

Thanks for the input. Gary

487
Views
5
Helpful
3
Replies