Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

cisco 7301 starts always in ROMMON mode

i have a new cisco 7301 with a CF-256. when start booting it displays two errors message : 'unknown CPU card ID in eeprom' and after : cannot determine first file on device "slot0:" '. After this step it displays the prompt of ROMON>

Any way to load the software correctly ?

helps

regards

2 REPLIES

Re: cisco 7301 starts always in ROMMON mode

try to format your CF-256 with cisco 7301

Re: cisco 7301 starts always in ROMMON mode

HI, [Pls RATE if HELPS]

Option: 1

You have removed the Flash card or the card insertion is incorrect. Issue the show flash executable command to verify the presence of the Flash card:

Switch(boot)# show flash

%Device in REMOVED state

Insert or reseat the Flash. If the problem persists, replace the Flash card. If a Flash card replacement does not resolve the problem, replace the switch router.

Option: 2

The Flash is empty or the file system is corrupt. Copy a valid image on the Flash, erase the Flash at the prompt, and reload the switch router.

Hope I am Informative.

Pls RATE if HELPS

Best Regards,

Guru Prasad R

480
Views
0
Helpful
2
Replies
CreatePlease to create content