Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 877 and Enet Encap

Hello! How to configure 877 router with enet encapsulation? Multiplexing LLC-based.

My config does not work, can you tell please, what's wrong:

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Cisco 877 and Enet Encap

What is your config supposed to reference? Are you connecting to a DSL provider? What type of connection is this? Did they assign you the IP address? Do you have some other device that is connecting to the router on the provider-facing side?

The config doesn't look complete, but it's hard to tell you what's missing without knowing what you're connecting to.

HTH,

John

HTH, John *** Please rate all useful posts ***
Hall of Fame Super Silver

Re: Cisco 877 and Enet Encap

Hello

use the following document

http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093e5f.shtml#configs

to implement IRB correctly you need also:

bridge ip protocol ieee

bridge 1 route ip

also to make a bridge also the lan interfaces or the Vlan1 needs to be associated to bridge-group 1.

But to be noted if you do so NAT is not needed or possible.

So you need to think about what you want to achieve

Hope to help

Giuseppe

3 REPLIES

Re: Cisco 877 and Enet Encap

What is your config supposed to reference? Are you connecting to a DSL provider? What type of connection is this? Did they assign you the IP address? Do you have some other device that is connecting to the router on the provider-facing side?

The config doesn't look complete, but it's hard to tell you what's missing without knowing what you're connecting to.

HTH,

John

HTH, John *** Please rate all useful posts ***
Hall of Fame Super Silver

Re: Cisco 877 and Enet Encap

Hello

use the following document

http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093e5f.shtml#configs

to implement IRB correctly you need also:

bridge ip protocol ieee

bridge 1 route ip

also to make a bridge also the lan interfaces or the Vlan1 needs to be associated to bridge-group 1.

But to be noted if you do so NAT is not needed or possible.

So you need to think about what you want to achieve

Hope to help

Giuseppe

New Member

Re: Cisco 877 and Enet Encap

Thank you very much! It was helpful.

933
Views
0
Helpful
3
Replies