Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring Channelized T1/E1 VWIC - Urgent Help Needed

I installed a new VWIC2-1MFT-T1/E1 card in my cisco 3825 router, and the router does see it, but I am unable to configure the "controller T1".

2 Gigabit Ethernet interfaces

60 Serial interfaces

8 Channelized T1/PRI ports

1 Channelized (E1 or T1)/PRI port

The new card is in slot 0/3, but I keep getting the error below:

RS_3825(config)#controller t1 0/3/0

^

% Invalid input detected at '^' marker.

Please help.

Thanks.

hieu

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Gold

Re: Configuring Channelized T1/E1 VWIC - Urgent Help Needed

Try the global command:

card type t1 0 3

You need to identify to the router if your using it as a T1 or E1

3 REPLIES
VIP Gold

Re: Configuring Channelized T1/E1 VWIC - Urgent Help Needed

Try the global command:

card type t1 0 3

You need to identify to the router if your using it as a T1 or E1

Community Member

Re: Configuring Channelized T1/E1 VWIC - Urgent Help Needed

Hello Chris,

Thank you for your help. I did just that and it worked great.

hieu

Silver

Re: Configuring Channelized T1/E1 VWIC - Urgent Help Needed

plz paste the show diag output..

cheers :)

satish

277
Views
5
Helpful
3
Replies
CreatePlease to create content