Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

copy tftp: nvram:startup-config

for 4503-E series and 4506-E series

I want to prepare the configuration offline.

When I tftp the configuration to nvram:

No SSH keys generated

VTP mode and domain not configured

While it gives no error at startup?

Is this not possible?

4 REPLIES
Hall of Fame Super Gold

Re: copy tftp: nvram:startup-config

Try this ...

1. Copy the configuration from the TFTP to your flash (copy tftp: flash:).

2. Once the copy has been successful, copy the configuration from the flash: to the running-config (copy flash: run).

New Member

Re: copy tftp: nvram:startup-config

I'll try it today.

Problem is that the blades are not in there. So it will give errors on the interface configuration.

Possibly when I'll do a write I'll loose these configuration. That's the reason for the copy tftp

It's as preparation for a migration where the chassis and sup will be upgraded while the existing blades will be kept.

New Member

Re: copy tftp: nvram:startup-config

the vtp information is not there because it is not stored in config.text, but rather vlan.dat.

New Member

Re: copy tftp: nvram:startup-config

yes correct. you may want to copy vlan.dat before you remove/delete it

1827
Views
0
Helpful
4
Replies