03-24-2003 06:43 PM - edited 03-05-2019 11:17 AM
Sir,
My cpu utility on C4k is always high even with any configuration and connection. After I remove a 4232 module, everything is ok. Please help me identity the problem.
Thank you very much!
Regards,
Sha, Haijiang
===================================
Console> (enable) sh proc cpu
CPU utilization for five seconds: 21.33%
one minute: 33.96%
five minutes: 24.97%
......
145 263 242 5000 0.00% 0.00% 0.00% -2 VtpRx
193 430939 54246 10958 1.30% 1.44% 12.38% 0 Packet forwardi
194 257203 69837 6468 15.70% 15.29% 16.72% 0 Switching overh
195 31091 54063 18817 1.96% 2.02% 1.97% 0 Admin overhead
......
===================================
Here is my c4k's module:
Mod Port Model Serial # Versions
--- ---- ---------- -------------------- ---------------------------------
1 2 WS-X4013 JAE0548xxxx Hw : 3.2
Gsp: 6.2(2.0)
Nmp: 6.2(2)
2 34 WS-X4232-L3 JAB0547xxxx Hw : 1.7
3 34 WS-X4232-GB-RJ JAE0548xxxx Hw : 2.3
03-24-2003 07:01 PM
Normal for a CAT4006
03-26-2003 12:14 AM
normal
01-06-2005 10:04 AM
I am having this same issue, my belief is that it's related to Broadcast traffic, but I have not gotten a straight answer from cisco.
01-07-2005 04:11 PM
This is normal , even with very little configured these will generally run at least 20-30% , just the nature of the beast just as the old 2924's run in this same area .
01-07-2005 08:18 PM
Problem is, I am starting to drop packets...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: