03-21-2006 06:41 AM - edited 03-05-2019 11:49 AM
Hi,
Is it possible for router B with two serial interfaces be configured with two default routes? The above router is connected to routers A and C. No routing protocol is configured, except for initial default routes.
Router B
s0 193.168.50.1/30
s1 193.168.50.5/30
Router A
s0 193.168.50.2/30
Router C
s0 193.168.50.6/30
Solved! Go to Solution.
03-21-2006 08:24 AM
Yes, it is possible. Set the next hop as the physical interface and I believe this will provide redundant load balancing configuration. If Router A or C shutdown or loss the serial connection router B will remove the router for the route table.
03-21-2006 07:11 AM
Hi
The simplest way is to configure RIP on all the routers.
Regards
JD
03-21-2006 08:24 AM
Yes, it is possible. Set the next hop as the physical interface and I believe this will provide redundant load balancing configuration. If Router A or C shutdown or loss the serial connection router B will remove the router for the route table.
03-21-2006 08:38 AM
Thanks. How do I check mark this to indicate resolved?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: