Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

default route

Hi,

Is it possible for router B with two serial interfaces be configured with two default routes? The above router is connected to routers A and C. No routing protocol is configured, except for initial default routes.

Router B

s0 193.168.50.1/30

s1 193.168.50.5/30

Router A

s0 193.168.50.2/30

Router C

s0 193.168.50.6/30

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: default route

Yes, it is possible. Set the next hop as the physical interface and I believe this will provide redundant load balancing configuration. If Router A or C shutdown or loss the serial connection router B will remove the router for the route table.

3 REPLIES

Re: default route

Hi

The simplest way is to configure RIP on all the routers.

Regards

JD

Bronze

Re: default route

Yes, it is possible. Set the next hop as the physical interface and I believe this will provide redundant load balancing configuration. If Router A or C shutdown or loss the serial connection router B will remove the router for the route table.

New Member

Re: default route

Thanks. How do I check mark this to indicate resolved?

123
Views
0
Helpful
3
Replies
CreatePlease to create content