03-21-2006 06:41 AM - edited 03-05-2019 11:49 AM
Hi,
Is it possible for router B with two serial interfaces be configured with two default routes? The above router is connected to routers A and C. No routing protocol is configured, except for initial default routes.
Router B
s0 193.168.50.1/30
s1 193.168.50.5/30
Router A
s0 193.168.50.2/30
Router C
s0 193.168.50.6/30
Solved! Go to Solution.
03-21-2006 08:24 AM
Yes, it is possible. Set the next hop as the physical interface and I believe this will provide redundant load balancing configuration. If Router A or C shutdown or loss the serial connection router B will remove the router for the route table.
03-21-2006 07:11 AM
Hi
The simplest way is to configure RIP on all the routers.
Regards
JD
03-21-2006 08:24 AM
Yes, it is possible. Set the next hop as the physical interface and I believe this will provide redundant load balancing configuration. If Router A or C shutdown or loss the serial connection router B will remove the router for the route table.
03-21-2006 08:38 AM
Thanks. How do I check mark this to indicate resolved?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide