Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dial back up on an 891

Hi There,

I am currently reviewing the 891 Router as a replacement for my 1811's in the field, but I am running into a problem with the dialer interface not working properly.

I've used what is essentially the same config from my 1811, and it works if I copy the config over line-by-line (the dialer binds, and I get a solid connection to my VPN), until I restart the router. At this point i get the errors

%Remove Dialer Profile Configuration first

%Warning:Use P2P interface for routemapset

                           interface clause

C

% Incomplete command

C

% Incomplete command

I seem to be at a loss for what this means, can someone help me out?

Thanks

1 REPLY

Re: Dial back up on an 891

Hi There,

I am currently reviewing the 891 Router as a replacement for my 1811's in the field, but I am running into a problem with the dialer interface not working properly.

I've used what is essentially the same config from my 1811, and it works if I copy the config over line-by-line (the dialer binds, and I get a solid connection to my VPN), until I restart the router. At this point i get the errors

%Remove Dialer Profile Configuration first

%Warning:Use P2P interface for routemapset

                           interface clause

C

% Incomplete command

C

% Incomplete command

I seem to be at a loss for what this means, can someone help me out?

Thanks

Check out the below link for configuration of dailer list in cisco 860,880 and 890 series routers

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf.html

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

1200
Views
0
Helpful
1
Replies