We are having a problem with a couple of pieces of equipment on our network not responding to ping and/or dropping it's connection to the server. All this started just after we installed our PIX 501, so i suspect it may be dropping packets from the INSIDE clients, can somebody review this config report and tell me if there are any settings that may hinder normal internal LAN traffic? Also, I set it up so PING should work/route through the PIX and back, but that doesn't seem to be working either.
It might be a nat problem but not to sure, try setting some deny statements in you ACL for nat to keep the source address from being changed and do some pings from behind the firewall. I know this is a problem in site to site VPN's allot of the time so maybe you will get lucky. access-list inside_outbound_nat0_acl deny ip a.b.c.d~~~>(source or host you are pinging from) this is assuming that all traffic is hitting the pix first.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...