Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel Non-adjacent Ports

I am trying to create an etherchannel between non adjacent ports on a 6509 running catos and a 4507 running ios. The switches are configured as follows:

Cisco 6509 running CatOS ver 8.4(5)

set trunk 1/1 on dot1q 1-4094

set port channel 1/1 mode on

set trunk 7/1 on dot1q 1-4094

set port channel 7/1 mode on

Catalyst 4500 running IOS ver 12.2(31)SG

interface Port-channel9

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

switchport nonegotiate

interface GigabitEthernet3/12

switchport trunk encapsulation dot1q

switchport mode trunk

switchport nonegotiate

channel-group 9 mode on

interface GigabitEthernet4/12

switchport trunk encapsulation dot1q

switchport mode trunk

switchport nonegotiate

channel-group 9 mode on

I disable all the ports involved, deliver the configuration and when I reenable the ports one line connects and the other line goes errdisabled and no channel is formed. What am I doing wrong?

Thanks in advanced

5 REPLIES
Hall of Fame Super Blue

Re: Etherchannel Non-adjacent Ports

Hi

On your 6500

set port channel 1/1,7/1 mode on

If you do it on 2 separate lines the switch doesn't know you want to channel these together.

HTH

Jon

Purple

Re: Etherchannel Non-adjacent Ports

Or you set your link to desirable non-silent and let the switch negotiate the channel .

catos

set port channel 1/1,7/1 desirable non-silent

ios

interface range g3/12, G4/12

channel-group 9 mode desirable non-silent

New Member

Re: Etherchannel Non-adjacent Ports

What is the errdisable cause? What type of card is module 1 and module 7? If they are different, QoS may complain.

There is a knob to disable checking for this in IOS:

"no mls qos channel-consistency"

CatOS also has a knob, but I don't believe it's available until 8.6(x):

"set port qos channel-consistency "

Silver

Re: Etherchannel Non-adjacent Ports

Also try removing "switchport nonegotiate" command. Turning off DTP does not have any effect since you have trunk mode manually set to ON. Not sure how CatOS functions - maybe it has problems establishing a trunk without DTPs.

Maybe this can be your cue to migrate to Native IOS :)

Purple

Re: Etherchannel Non-adjacent Ports

there should be no problem with channeling between a catos box and a ios box . Have you looked in the logs , usually it will give you an idea why it err-disabled a port . The other thing to check seeing that you are trunking also is to make sure both ends are using the same native vlan for all ports involved. On the catos side it will just be whatever the ports will fall back to if the channel fails, this is set by the set vlan X slot/port command . On the IOS side you need to add the switchport trunk native vlan X" command . The way it is now it is assuming that everything is in vlan 1 which I don't know if its true or not . What vlan are the ports on the catos side set into ? you also just use the following after verify the native vlan is the same on both sides . Use channel-group X mode desirable non-silent and on the catos side use "set port channel slot/port mode desirable non-silent .

387
Views
0
Helpful
5
Replies