Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EtherChannels

Hi, I just want to confirm I have configured my network right:

I have 2 sites, A and B. Each has a 3560G and using 2 ports on each switch, I have trunked them and created an EtherChannel.

on A:

int range gi0/1 - 2

switchport trunk encap dot1q

switchport mode trunk

channel-group 1 mode auto

and the same on B:

int range gi0/1 - 2

switchport trunk encap dot1q

switchport mode trunk

channel-group 1 mode auto

What I really want to check, is it correct to set the channel-group number as the same value on both sets of ports on both sides?

1 ACCEPTED SOLUTION

Accepted Solutions
bjw Silver
Silver

Re: EtherChannels

channel-group numbers are only significant on the local switch. They do not need to match across switches. And can be set to the same value without affect.

Also note that in Pagp, if both sides of the etherchannel are in AUTO, it won't work. If one side is in Auto, the other needs to be in DESIRABLE. Or you could put both sides to mode ON.

2 REPLIES
bjw Silver
Silver

Re: EtherChannels

channel-group numbers are only significant on the local switch. They do not need to match across switches. And can be set to the same value without affect.

Also note that in Pagp, if both sides of the etherchannel are in AUTO, it won't work. If one side is in Auto, the other needs to be in DESIRABLE. Or you could put both sides to mode ON.

Re: EtherChannels

Hi,

Using auto PAgP on both switches prevents the PortChannel from forming dynamically. You should use desirable mode on one of them.

[edit] Sorry Bill didn't see your reply.

HTH,

Mohammed Mahmoud.

110
Views
0
Helpful
2
Replies