Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Extended IP access list for NAT

Hi, all.

Give me informations on access list for NAT.

Cisco IOS Master Command List, Release 12.4 describes the ip nat inside destination command, the ip nat inside source command, and the ip nat outside source command use standerd IP access list for dynamic NAT.

But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.

They leave me in confusion.

Regards

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Extended IP access list for NAT

Hi,

Not specific to 12.4 but the below link will help for nat.

http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html

Regards,

Pravin

3 REPLIES
Community Member

Re: Extended IP access list for NAT

>But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.

Hyperlinking slipped my mind.

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml

Regards

Re: Extended IP access list for NAT

Hi,

Not specific to 12.4 but the below link will help for nat.

http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html

Regards,

Pravin

Community Member

Re: Extended IP access list for NAT

Thanks for your advice.

Regards,

haa33110

5480
Views
0
Helpful
3
Replies
CreatePlease to create content