I am looking for a way to add an extra ethernet port on my 2610. What i have read is making me wonder if the only way to do this would be the NM-1E or NM-4E. Are there any other modules or WICs that would give me an fast/ethernet port?
If you already have a Catalyst switch, and if it and the 2600 can support VLAN trunks, you might be able configure multiple logical interfaces on the 2600's Ethernet interface and use another physical port off the Catalyst to connect to the modem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...