Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FastEthernet NM

I have voice interface NM with 2 voice port that was installed in slot#1 of my cisco 3600 router. I have to remove this voice interface NM as our company requirement and install a new FastEthernet NM with 2 WAN port. On these 2 WAN port I installed the 2 voice port from the old voice interface NM. When I power up my router and check the configuration the new FastEthernet NM was not detected by the router and the LED at the NM backplate was inactive. Only the orange lights from the voice port was on and obviously were not also active. What could be the problem? Is it possible that the new FastEthernet network module is problematic? And is it ok to install a voice-port to a WAN port?

Thanks.

2 REPLIES
Bronze

Re: FastEthernet NM

Hi friend, check if your new NM is compatible with your Cisco 3600, you can try installing the NM without any voice card to check if your NM is recognized.

Good luck and best regards

David

Hall of Fame Super Gold

Re: FastEthernet NM

It won't work. The VIC card will only work with Voice NM cards only.

176
Views
0
Helpful
2
Replies