Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

garbled output

Hi Folks,

I have a 7300 router, running 12.2.27sbc1

the only problem I have is output of the show config, it is garbled,

the show run, show start, are ok,

and it is garbled at the same portion of the config always,

there is no problem with my session, it is an OC3,

I will include an example of the garbled output:

Retried the sh conf - it fails again

ehbgrt8#sh conf | inc 10.175.0.0

access-list 103 permit ip 10.175.0.0 0.0.255.255 any

Note the garbled route

ehbgrt8#sh conf | inc 10.175

ip route 10.175.ip route 12.38.144.128 255.255.255.192 172.21.128.2

strange huh ?

I tried to writet mem, and it works, but the problem is still there,

I researched the bug toolkit for this one, and did not see, or maybe I did not cover all the possible keywords in my search,

any help, or if you know a bug id, I would appreciate it.

thanks

1 REPLY
Bronze

Re: garbled output

Hi,

from where are you executing the command (show config), from a VTY (Telnet) session, or from a console session ? The problem might be with your emulator software, which one do you use (Hyperterminal, TeraTerm) ?

Nethelper

140
Views
0
Helpful
1
Replies
CreatePlease to create content