10-10-2005 07:27 PM - edited 03-05-2019 11:39 AM
How i can configure multilink on 2600 router with two serial interfaces.I have terminated two E1 lines at both serial interfaces.How to do the load sharing.
10-10-2005 08:57 PM
hi
Do create a multilink link interface using interface multilink command,ip address to be used for the bundle,encapsulation PPP,multilink ppp and do key in no shut under the same.
now you need to change the encapsulation on the serial interfaces which you want to bring under the multilink bundle.
Make them as the member of the particular multilink using multilink group 1 (based on the interfafce numbering u give for the multilink interface).
I would suggest to get your E1 lines checked for both reliability as well for any errors if any so that you can have good throughput with the multilink bundle.
Also do refer this link for more info..
http://www.cisco.com/en/US/tech/tk713/tk628/technologies_configuration_example09186a00800a5efa.shtml
regds
10-10-2005 11:46 PM
thanks for your help.
will let you know when its done.
Regards
Rajesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide