Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

I can't resolve error message

Any idea what I need to do to resolve error message? Thanks

%AMDP2_FE-5-EXCESSCOLL: Ethernet1/0 TDR=1, TRC=0

4 REPLIES
Purple

Re: I can't resolve error message

You either have a speed/duplex mismatch between E1/0 and whatever is on the other end or you have way too much traffic on a half duplex link which there is no way to fix without getting interfaces that will do full duplex on each end . If E1/0 will do full duplex check to see if whatever is on the other end can and set them both to 10/full .

New Member

Re: I can't resolve error message

I have a 2600 router and 2950 switch. Current my e0/0 router is connected to a dlink to reach the internet. E1/0 is connected to my fa1/0 switch. Nothing else is connected. I'm trying to get the switch and router to talk, but no luck. I set the switch to full duplex, but I don't know where to check it on the router. If you don't mind, helping. What commands am I suppose to have on the vlan and fa to connect to the router. The IP for 0/0 on the router is 192.168.0.180 and for 0/1 is 10.0.0.1. The switch vlan is 10.0.0.2. I really appreciate your assistance.

Hall of Fame Super Gold

Re: I can't resolve error message

Connect the router to your 2950.

Router:

Interface e0/1

ip address 10.0.0.1 255.255.255.0

speed 10

duplex full

no shutdown

2950

Interface

speed 10

duplex full

no shut

int vlan 1

ip address 10.0.0.2 255.255.255.0

no shutdown

Hall of Fame Super Gold

Re: I can't resolve error message

What is the appliance connected to Ethernet1/0? Hard-code/force the duplex setting of that appliance to full duplex, 10 might help.

180
Views
0
Helpful
4
Replies
CreatePlease to create content