01-06-2008 07:12 PM - edited 03-05-2019 08:18 PM
Here again Friends with an error message disallowing communication two serial interfaces. The interface and the line is up as you can see from the sh ip int s1/0 command but could not ping the second device because of this error.
Serial1/0 is up, line protocol is up
Internet protocol processing disabled
Please help out somebody!!!!!!!!
Regards
01-06-2008 07:22 PM
That message would typically either mean that the interface did not have an IP address configured or perhaps that the router was configured with no ip routing. My guess at this point is that the interface does not have a valid IP address configured. Can you post the output of show ip interface brief and perhaps post the configuration of the interface.
HTH
Rick
01-06-2008 07:28 PM
Heyyyy Rick you the mannnn!!!!!!!!!!!
Thanks a billion for your help. I actually placed the IP on a wrong interface.
It's now resolved with your help.
Most grateful
01-06-2008 07:33 PM
I am glad that my response pointed you in the right direction.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide