First, there is an inconsistency in your question. Is it 18.104.22.168 or 22.214.171.124? I suppose it's 126.96.36.199 and try to give you an explanation.
For the inverse mask ussed in ACL,bit "0" means match exactly, bit "1" means don't care. In this case, the topmost 6 bits of the third octect (and all bits in 1st and 2nd octes) should match exactly and the rest of the bits need no care.
So, any address with this pattern: 001000xx xxxxxxxx (where x = 0 or 1)will match the source address field of the ACL. Writing these addresses in binary format, they should be:
00100000 00000000 to 00100011 11111111
or in digtal format:
32.0 ~ 35.255
To your question, any address ranging from 188.8.131.52 to 184.108.40.206 will match the source address field in the ACL.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...