Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ios image and config

I downloaded a ios file from cisco site. it is saved on my desktop, what is the easy way to copy it from the dsktp to the router.there is no scp or tftp on my Lan, will establish that later, but for now just needed the easy install.. Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: ios image and config

The best way is by ethernet, either by FTP or TFTP. You'll need to install a server on your PC, there's no way around it unless you want to spend 8 hours copying the config by xmodem with a console cable.

I just fire up the IIS FTP server on my PC and use that, but you could download a free tftp server here:

http://www.solarwinds.com/products/freetools/

Make sure you have enough flash memory to hold the image by typing "dir" and checking the available space. Delete files if required ("delete flash:/filename"). You may have to squeeze the flash depending on the router type "squeeze flash:".

Depending if you used tftp or ftp, use the following commands to copy the file:

copy ftp://username:password@x.x.x.x/directory/filename.bin flash:

or

copy tftp://x.x.x.x/directory/filename.bin flash:

Follow the prompts. If you have only one image in flash, reboot the router and you get the new version. If you have multiple, enter the command "boot system flash:/filename.bin" to make sure it boots the image you want.

Good luck,

Ryan

3 REPLIES
Bronze

Re: ios image and config

The best way is by ethernet, either by FTP or TFTP. You'll need to install a server on your PC, there's no way around it unless you want to spend 8 hours copying the config by xmodem with a console cable.

I just fire up the IIS FTP server on my PC and use that, but you could download a free tftp server here:

http://www.solarwinds.com/products/freetools/

Make sure you have enough flash memory to hold the image by typing "dir" and checking the available space. Delete files if required ("delete flash:/filename"). You may have to squeeze the flash depending on the router type "squeeze flash:".

Depending if you used tftp or ftp, use the following commands to copy the file:

copy ftp://username:password@x.x.x.x/directory/filename.bin flash:

or

copy tftp://x.x.x.x/directory/filename.bin flash:

Follow the prompts. If you have only one image in flash, reboot the router and you get the new version. If you have multiple, enter the command "boot system flash:/filename.bin" to make sure it boots the image you want.

Good luck,

Ryan

Re: ios image and config

Hi,

The previous post is also very helpful, with a little addition on that if you have an usb port on your cisco router, use a pen drive to your router put the bellow syntax #format usb0:, unplugh the usb drive, put it to your desktop, copy the flash, put it again to your router, then put the command: # copy usb0: flash .bin [file name]

Thanks

Goutam

pls rate if it helps you

Bronze

Re: ios image and config

This is a great method, but it depends on the version of IOS if you have access to the USB port as a memory location. It's a pretty new feature. Definitely worth a try.

Ryan

317
Views
14
Helpful
3
Replies
CreatePlease login to create content