Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP change with a ASA 5505

Hello

Attempting to deploy an ASA 5505 as a basic router, i have to change default IP (192.168.1.1) to a new one (192.168.3.1).

From the DSAM interface I edit with a right click my inside configuration and modify the value.

Then I valid and apply. The DSAM interface warn me about disconnection, as my IP isn't on the same subnet.

I leave the interface, i change my laptop IP and can ping the router with is new IP 192.168.3.1 but i can't open the admin interface.

After a reboot, the router IP is back to the default 192.168.1.1

Any Ideas ? thanks for answers.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: IP change with a ASA 5505

you changed IPs , disconnected from fw by the change, change laptop ip and you can ping the interface, however, you never told the asa which IPs can telnet or http to the firewall for management withing the new IP/subnet change, you rebooted and old ip came back because you never saved the config.

coulple of things you could do before changing the IP.

Instruct asa to allow any IP inside your lan to access it .

This is more efective as you are not bound to a subnet.

http 0.0.0.0 0.0.0.0 inside

telnet 0.0.0.0 0.0.0.0 inside

or per subnet

http 192.168.3.0 255.255.255.0 inside

telnet 192.168.3.0 255.255.255.0 inside

Once you make the IP change get back into asa and save config.

HTH

Jorge

2 REPLIES

Re: IP change with a ASA 5505

you changed IPs , disconnected from fw by the change, change laptop ip and you can ping the interface, however, you never told the asa which IPs can telnet or http to the firewall for management withing the new IP/subnet change, you rebooted and old ip came back because you never saved the config.

coulple of things you could do before changing the IP.

Instruct asa to allow any IP inside your lan to access it .

This is more efective as you are not bound to a subnet.

http 0.0.0.0 0.0.0.0 inside

telnet 0.0.0.0 0.0.0.0 inside

or per subnet

http 192.168.3.0 255.255.255.0 inside

telnet 192.168.3.0 255.255.255.0 inside

Once you make the IP change get back into asa and save config.

HTH

Jorge

New Member

Re: IP change with a ASA 5505

That's all folk !

Thank you for your help.

401
Views
0
Helpful
2
Replies