Cisco 3560 with two
1Gbps uplinks and 48 10/100Mbps ports
Swich B and C
With two 1Gbps uplinks and 24 10/100 Mbps ports each
is a server with two Logical partitions. ( namely X and Y)
logical partions of the server should be connected to 3560 via Two
two 2960 swiches should connect to 3560 switch
pcs connect to 2960 switches.
be two VLANS namely 10 and 20. user belong to vlan 10 should only have
access to X Partition. similarly vlan 20 users have access to Y.
suppose there are 3 users called 1,2,3
user 1 should have access to X
partition only. user 2 have access to Y only
user 3 should have
access to X and Y both
also there should be required communication
between X AND Y .
What is the best solution for this ?
I would suggests connect the cisco 2900 series switch to 3560 switch via trunk port configuration and configure SVI in 3560 switch for both vlan which will act a gateway for resopective vlan users and intervlan routing will happen without any problem.In order to restrict users accessing server you can create ACL in 3560 switch with source and destiona and apply that in in bound direction in vlan interface.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...