I am very new to the world of the mystical computer. I am currently studying for my ccent and I am using some instructor prepared practice tests. I have hit a bit of a wall on a few of the questions and would greatly appreciate some help. I will start with the easer of the two.
#1. which of the folllowing commands are interface defaults in a cisco switch
a. switdhport mode access
b .switchport port-security
c. switchport port-security mac-address sticky
d. switchport port-security max 1
e. switchport portsecurity violation restrict
f. no shutdown
I know that f is a default, butt I am a little lost on the other?
#2. What is a reason to not use the logging synchronous command?
a. to see debug messages
b. to see buffer log messages
c. to see logs a debugs during a reload
d. to see log and debugs during a ping
I know that the logging synchronous command will prevent interruptions in typing. however I am not familiar enough with debugs and troubleshooting to know when you would want to be interrupted?
I would appreciate any guidance that can be offered in answering these questions
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...