Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mac filtering configuration

We need to configure a mac filter on a bunch of the cisco 2950 switches to allow only certain devices in. Short of manually doing it, has anybody done this in a more efficient way?

thanks

2 REPLIES

Re: mac filtering configuration

Hi,

What I understand is that you want only specified devices to be on your network, isnt it?

Well, what you can do is define a mac address based access control list and then apply a vlan-map to block or pass the traffic from those mac addresses.

Have a look at the following link for more -->

http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_example09186a0080470c39.shtml

The following URL might help as well -->

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_guide_chapter09186a008007fa38.html#1020942

Hope this helps...

Regards,

AbhisheK

Please rate helpful posts!!!

Re: mac filtering configuration

I think that 802.1x will help you ...

I think what you want is to either block specific devices to access a switch/network right?

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

125
Views
0
Helpful
2
Replies
CreatePlease login to create content