Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT Configuration woes

Hi all,

I've been struggling with configuring my shiny new 871 ISR to work using NAT, and I've had absolutely no luck.

I can ping (from an inside PC) this inside interface of the router, as well as the outside interface of the router.

from the router, I can ping everything.

I just can't get from the internal PC to outside at all. I've snooped the traffic on another PC that is on the outside "WAN", and there's no traffic.

I've used the SDM tool to create the NAT rules, and also stripped out everything but the basics, but nothing seems to help.

This is really driving me crazy. Any help would be much appreciated. Maybe it's something too obvious that I'm missing?

Thanks,

Matt

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: NAT Configuration woes

Matt,

You have "no ip routing" in your config. This prevents the router from functioning properly. try this:

router#config t

router(config)#ip routing

router(config)#ip cef

4 REPLIES
Silver

Re: NAT Configuration woes

Matt,

You have "no ip routing" in your config. This prevents the router from functioning properly. try this:

router#config t

router(config)#ip routing

router(config)#ip cef

New Member

Re: NAT Configuration woes

I can't believe I missed that.

Thanks, that's done it!

In regards to your next message, shouldn't that remain as .1, since that's the next-hop router? (default gateway)

Silver

Re: NAT Configuration woes

OK, that was not clear in the config.

Silver

Re: NAT Configuration woes

also your "ip route 0.0.0.0 0.0.0.0 10.10.1.1" seems to be pointing in the wrong direction. It should be pointing to your WAN interface, which appears to be 10.10.1.111.

122
Views
0
Helpful
4
Replies
CreatePlease login to create content