cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
229
Views
0
Helpful
2
Replies

NAT problems on 1811W

Luke.Ercoline
Level 1
Level 1

Hello all, not sure if this is where I should post this but here goes. I have an 1811W and would like to set each Fast Ethernet port to have its own NAT defined.

Here's my reasoning. I am trying to setup a roll-over for my Internet connection. If the main line (cable) goes down, it will pick up the second line (DSL) automatically. I have the routing tables setup to do this, but the NAT does not work. It will only use the one that was designated for the main Fast Ethernet.

I do not want to go with something like OER (optimized edge routing), because that just seems more confusing and I do not know where to begin with that. Any help would be appreciated. thanks

Luke

2 Replies 2

vladrac-ccna
Level 5
Level 5

hello Luke,

just to understand your scenario.

You said that you have "ip nat outside" in 2 interfaces and this is not working?

could you give us more details about your actual configuration.

vlad

Sure thing vlad. I will get the actual config when I go back to the office tomorrow.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: