Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not able to ping the switch from the computer

The switch has a vlan 5 created and defined to g1/0/35 and is active w/ip

10.10.10.1/8. Laptop is 10.10.10.2/8. However I am unable to ping between the two.

1 REPLY
New Member

Re: Not able to ping the switch from the computer

Hi, reading your post made me wonder what is the default gateway of your switch?, is it the IP of vlan 5. Sounds like you want vlan 5 to be the management vlan. Also is your laptop on a port that is in vlan 5? if not you will need inter vlan routing enabled or assign te switchport to vlan 5. Did you do a ipconfig /all on your laptop and check the IP of the default gateway? I hope this is helpful for you, I am doig some guessing here due to the fact i dont know your entire network setup. Check out the link below.

!-- Set the IP address and default gateway for VLAN1 for management purposes.

3512xl#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

3512xl(config)#int vlan 1

3512xl(config-if)#ip address 10.10.10.2 255.255.255.0

3512xl(config-if)#exit

3512xl(config)#ip default-gateway 10.10.10.1

3512xl(config)#end

http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a00800949fd.shtml

141
Views
0
Helpful
1
Replies