Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Number of OSPF areas?

Happy New Year to all who may read my post :)

We have multiple L2 VLAN's on our 6509's and I am tasked to setup dynamic OSPF routing.

Which is better; cpu, memory and effective configuration.

1) create a OSPF area for each VLAN

2) create 1 OSPF area with all the VLAN's in it

off course our core are will be 0.0.0.0 which will span to all inter office router's connection points.

any advise/reading material on the subject would be greatly appreciated.

2 REPLIES
Hall of Fame Super Blue

Re: Number of OSPF areas?

Hi

It is highly unlikely that you would want a separate area per vlan on your 6500 switch. That would make your configuration very complex.

If you have multiple offices one common setup is to have HQ as area 0 and your remote sites in different areas but without knowing more about your topology it is difficult to be more specific about what is good for you.

Attached is a link to Cisco white paper on OSFP design, have a read and them come back if you require further assistance.

http://www.cisco.com/en/US/tech/tk365/technologies_white_paper09186a0080094e9e.shtml

HTH

Jon

New Member

Re: Number of OSPF areas?

Jon,

Thank you for the quick response, I have read this doc a few times and all the example configs in this guide only has 1 network assigned to an area.

Short of a lab; I just needed some clarification on the approach which I had stuck in my head :-)

Donny

125
Views
4
Helpful
2
Replies
CreatePlease to create content