Hello, I have a refurbed 4948 that I configured, I upgraded the IOS from 12 to 15.0, and I noticed it still has acl entries in it from the old owner, so I tried to remove them, by going on config mode and removing them but somehow when I go to type sh access-list, they all show up again, the commands don't stick somehow.
I tried setting up a test acl, and was able to remove that, but the old ones are somehow stuck, it's not affecting any of my current configs since the ip's are not the same on the acl and my lan. Any ideas or pointers, thanks in advanced.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...