Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

packet-buffer err-disable .. i don't understand.

Error for WS-X6516-GE-TX

03:23: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 6 is experiencing the following error: Transient port ASIC (PINNACLE) packet buffer parity error detected on ports 1, 2, 3, 4,

00:03:23: %PM-SP-4-ERR_DISABLE: packet-buffer error detected on Gi6/1, putting Gi6/1 in err-disable state

00:03:23: %PM-SP-4-ERR_DISABLE: packet-buffer error detected on Gi6/2, putting Gi6/2 in err-disable state

00:03:23: %PM-SP-4-ERR_DISABLE: packet-buffer error detected on Gi6/3, putting Gi6/3 in err-disable state

00:03:23: %PM-SP-4-ERR_DISABLE: packet-buffer error detected on Gi6/4, putting Gi6/4 in err-disable state

thanks for you. it's help to me.

1 REPLY
Silver

Re: packet-buffer err-disable .. i don't understand.

It could be cause of following:

A cable that is out of specification (either too long, the wrong type, or defective)

A bad network interface card (NIC) card (with physical problems or driver problems)

A port duplex misconfiguration

To eliminate the problem.. follow below document check one by one.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml

Regards,

Dharmesh Purohit

3154
Views
0
Helpful
1
Replies
CreatePlease login to create content