I read that for configuring PAP authentication in a serial PPP link we need the following commands. I am using R1 and R2 as example:
username (R2) passsword (word) - Global command.
encapsulation ppp (int subcommand)
ppp authentication pap (int subcomand)
The same commands in R2 but configuring the username as R1.
Once I enter the "ppp authentication pap" command the link goes down.... is there any reason for this behavior? Is there any crazy thing like needing the cable to be unplugged before setting the configuration and plugged back once the configuration is done?
This is my configuration in R1:
username R2 password 0 carro
ip address 220.127.116.11 255.255.255.252
ppp authentication pap
Help please to understand why... I am doing what the book says.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...