Your'e config looks okay although it's difficult to be certain it is doing what you want without more detail from you. Couple of things
1) The following 2 routes
ip route 126.96.36.199 255.255.252.0 FastEthernet0/0
ip route 192.168.30.0 255.255.255.0 FastEthernet0/1
Not sure why you need these as you have directly connected interfaces on the router for these networks.
2) Your NAT pools do not have enough addresses in them to cover the class C networks you are translating from. if there is a possibility the NAT pool may run out you may want to add the keyword "overload" to the end of your NAT statements.
and 192.168.12.0 throught out the router to the internet from the sw3550...
i wasnt sure if i should add static route entries about the 10.2.145.0 and 10.2.146.0 networks because i was confused about the nat order operation but seems that the router recognize only the original network when routing operates.
With your current configuration the router wouldn't NAT the traffic from 192.168.12.0 and 192.168.30.0 network because of PBR. PBR operation takes precedence over anything else and therefore NAT will be bypassed completely in your setup. As such your inside addresses would show up on the 3550 switch on the outside network. Instead of PBR use static route(s) + NAT to accomplish this task.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.