06-16-2008 05:00 AM - edited 03-05-2019 11:39 PM
I'm struggling to find any QoS guides that would contain any information for a 4506 runnign CatOs, all the config guides only seem to be tailored for IOS.
Does anyone have any experience/documentation for configuring QoS on a 4506 running CatOS?
I'm only after some basic QoS setup for voice, trust cos 3 and 5, etc
thanks
elena
06-16-2008 06:32 AM
Use the QOS CatOS config guides for the 6500s, they're nearly identical.
Hope that helps
06-16-2008 09:24 AM
Thanks i'll give it a go
06-16-2008 06:39 AM
Hi,
This link can provide you with the answeres.
http://www.cisco.com/en/US/products/hw/switches/ps663/products_qanda_item09186a0080094869.shtml
Hope this helps.
Regrds,
pravin
06-16-2008 09:25 AM
thanks for the reply, i've seen that doc already, unfortunately, all the config links seem to lead to IOS configuration guide :-(
06-20-2008 12:05 PM
The configuration guides for Catalyst 4x00 CatOS are now in the 'end of life/end of sale' documentation pile...
Here is the latest Cat 4000 software 8.3 & 8.4 guides for QoS.
http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/8.3and8.4glx/configuration/guide/qos.html
There isn't much.... All interfaces are 2q1t and all you can do is Map CoS values to queues, so only Layer-2 802.1p CoS is supported (no Layer-3 DSCP/IP Precedence support). You can set a default CoS value (i.e. rewrite or add an 802.p priority to all incoming frames) and there is no support for ingress or egress polcies (like there is with the Sup2+ and IOS on the 4500).
HTH
Andy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: