Replaced network device with same ip - cannot access ssh/http

[theflakes]

Hello-

I replaced a network equalizer and used the same ip. 

<www> - <firewall> -<netequalizer>-<cisco core>-<lan>

I can see this online and we are passing traffic.  Yet cannot access ssh or http. I have been troubleshooting with netequalizer but figure i come here. I am thinking this may be an arp issue on the cisco core? Any thoughts?

thanks

[Richard Burts]

While it might be possible that it is an arp issue on the core I think it is not so likely. Can the core ping the netequalizer? If the core can ping then it almost certainly is not an issue with arp.

My guess is that there was something in the configuration of the previous netequalizer then enables management by SSH and HTTP that was not done in the configuration of the replacement.

HTH

Rick