Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Replaced network device with same ip - cannot access ssh/http

 

Hello-

 

I replaced a network equalizer and used the same ip. 

 

<www> - <firewall> -<netequalizer>-<cisco core>-<lan>

 

I can see this online and we are passing traffic.  Yet cannot access ssh or http. I have been troubleshooting with netequalizer but figure i come here. I am thinking this may be an arp issue on the cisco core? Any thoughts?

 

thanks

 

 

  • Getting Started with LANs
1 REPLY
Hall of Fame Super Silver

While it might be possible

While it might be possible that it is an arp issue on the core I think it is not so likely. Can the core ping the netequalizer? If the core can ping then it almost certainly is not an issue with arp.

 

My guess is that there was something in the configuration of the previous netequalizer then enables management by SSH and HTTP that was not done in the configuration of the replacement.

 

HTH

 

Rick

109
Views
0
Helpful
1
Replies
This widget could not be displayed.