Hi, your BVI interface looks good, but if you want to route for vlan3 you need to enable dot1Q on your ethernet0/0 interface , you have the bridge-group 1 command on that interface, try adding "encapsulation dot1Q 1" on ethernet0/0. i was just tasked with adding several BVI interfaces on our network and had to overcome some bridge-group problems myself. HTH
Thanks Donald for your answer. I tried your suggestion but results are not so good. Pings from MAR to PCA on f0/0 operates properly. Pings from MAR to PCB on f2/0 does not work. PCB receives the ping request and replies, but the MAR does not receive it. "debug ip icmp" provides no trace.
I attach the configuration file <>. It should be nice if you can have a look.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...