routing protocols

[carl_townshend]

If I have a router with 2 interfaces, say 192.1.1.1 and 172.1.1.1, both /24 mask and I advertise these in eigrp, first of all what gets advertised, is it the interface and network, and also If I had a network statement in eigrp saying network 10.0.0.0 but didnt have any interfaces on this address would it advertise the network ?

thanks

[scottmac]

Carl .... check out this link; it's to Cisco Internetworking Guide Online. The equivelant book is many inches thick.

The online version is broken down into nice short, easy-to-read segments, covering all aspects of basic networking and internetworking.

http://www.cisco.com/univercd/cc/td/doc/cisintwk/ito_doc/index.htm

It will explain everything ....

Good Luck

Scott

[stephtchoko]

For the network 10.0.0.0 to be avertise, the network have to appear in routing table as direct connected.One interface have to get ip address on this network .

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d02a.html#wp1040780

Regards.